Victron – BlueSolar PWM-LCD+USB 12/24V-10A


The BlueSolar PWM-Pro series is ready for use with its default settings. It also is fully programmable.
• Lighting control function, fully programmable.
• Three stage battery charging (bulk, absorption, float), fully programmable.
• Integrated battery monitor function (Remote Panel needed to display state of charge).
• Load output with low voltage disconnect and manual control (default setting).
• Optional external temperature sensor.
• Load output protected against over load and short circuit.
• Protected against reverse polarity connection of the solar panels and/or battery.
• Day/night timing options: see manual Remote Panel for details.


Manufacturer: Victron


Model: Blue Solar – PWM-LCD+USB 12/24V-10A

Spec Sheet: Datasheet-BlueSolar-Charge-Controllers-12-24V-LCD&USB-EN


Liquid crystal display: For status monitoring and set-up.

Load output: Over-discharge of the battery can be prevented by connecting all loads to the load output. The load output will disconnect the load when the battery has been discharged to a pre-set voltage.
Some loads (especially inverters) can best be connected directly to the battery, and the inverter remote control connected to the load output. A special interface cable may be needed, please see the manual.The connect and disconnect voltages are adjustable.

Day/night timing of the load output: This option allows for a pre-set ON-time after dusk.
Programmable battery charge algorithm: Preprogrammed algorithms for AGM, GEL, Flooded or LiFePO4 batteries (with internal BMS only)

Two 5 Volt USB outputs Maximum current (both outputs combined): 2A